6
ELECTRONIC CONTROLS
OPERATION
Electronic Control Panel
Power Control
The Power Control turns the unit on and off.
Set Temperature/ Timer Display
Shows the set temperature when the unit is in operation and hours
when the timer is being set.
THE TEMPERATURE DISPLAY ONLY
SHOWS THE SET TEMPERATURE, NOT THE ACTUAL ROOM
TEMPERATURE.
Temperature/ Timer Hour Controls
These buttons are used to raise or lower the set temperature in
increments of 1° from 66° to 88°. By depressing both buttons at once,
the display will toggle between Celsius and Fahrenheit. When the
timer is being set, these buttons are used to change the hour setting in
increments of 1 from 00 to 24.
Mode Control
A green light will indicate which mode is currently being utilized.
Cool Mode –
The unit will circulate and cool the air.
Fan Mode –
The unit will only circulate the air.
Energy Saver Mode –
The fan will switch from the set fan speed to LOW whenever the
compressor turns off in response to the thermostat. When the
compressor cycles back on, the unit will return to the original fan
setting.
Fan Speed Control
High, Medium, Low and Auto
The settings are adjusted with the Fan Speed Control, each time the
button is depressed it changes the setting. A green light will indicate
which setting is currently being used.
When the AUTO feature is selected while the air conditioner is in the
COOL or HEAT mode, the fan speeds will change automatically as
the temperature in the room changes.
• 7° or more above the set temperature will use HIGH FAN.
• 4° – 7° above the set temperature will use MED FAN.
• 4° or less above the set temperature will use LOW FAN.
Timer Control
The timer can be set to either turn the unit on or off.
To turn the unit on using the Timer:
Depress the timer key when the power is off, the display will read 00.
Adjust to the desired number of hours before TURN ON using the
up/down arrows.
The display will show the time by hours left until TURN ON.
To Turn the timer off, depress the timer key.
A green light next to the Timer Control indicates that the timer is set.
To turn the unit OFF using the Timer:
Depress the timer key when the power is on, the display will read 00.
Adjust to the desired number of hours before TURN OFF using the
up/down arrows. The display will automatically go back to the set
temperature after 10 seconds.
To display the amount of time left until TURN OFF, depress the timer
button once.
To turn the TIMER OFF, depress the timer button twice.
A green light next to the Timer Control indicates that the timer is set.
Air Exchanger
Circulates fresh air and helps remove stale air when in the open
position. Maximum air circulation and cooling occur when in the
closed position.
Built-in three minute timing delay.
If this electronic unit will not respond to touch pad or remote control
commands, it is necessary to unplug the unit from the electrical outlet
for five seconds and then plug the unit back in.
Auto restart feature:
In the event of a power failure, this feature allows the unit to
resume operation once power has been restored, retaining the
most recent settings. Upon restoration of power, the timer
mode may need to be reset if being utilized
The functions work the same as your air conditioner’s touch controls.
Air Conditioner Remote Control
D
G
G
E
F
A
C
C
D
E
F
A
B
B
AAA
IEC R03
1.5V
+
-
AAA
IEC R03
1.5V
CAUTION
• Use only AAA or IEC R03 1.5V batteries.
• Remove the batteries if the remote controller is not used for a month
or longer.
• Do not attempt to recharge the supplied batteries
• All batteries should be replaced at the same time.
• Do not dispose of the batteries in a fire as they may explode.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon - zinc), or rechargeable
(nickel-cadmium) batteries.
• Do not install the batteries with the polarity (+/–) reversed.
• Keep batteries and other things that could be swallowed away from
young children. Contact a doctor immediately if an object is
swallowed.
Содержание A6V05S2B
Страница 23: ......
