24
Cushion Cleaning and Disinfection
The cushions can be easily cleaned.
WARNING!
Do not use bleach when washing the cushions. Doing so may cause damage to
the cushions
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or
cleaning agent before applying it to your product. Failure to comply may result in skin
irritation or premature deterioration of upholstery and/or power chair finishes.
To clean the cushions:
1. Remove the cushions by detaching the reusable hook and loop fasteners that secure the cushions, and
then pulling the cushions toward you.
2. Using a damp cloth and a mild, non-abrasive cleanser, spot clean the cushions as necessary.
3. Allow the cushions to air dry.
WARNING! Never submerge the cushions in water. Doing so may cause damage to the
cushions. WARNING! Do not attempt to put cushions in a dryer. This may cause shrinking.
4. Once the cushions are dry, position the cushions so that the reusable hook and loop fastener tabs face the
seat and seatback. Place the cushion over any lumbar support(s) and then secure the cushions to the seat
and seatback using the reusable hook and loop fasteners.
Wheel Replacement
If your chair is equipped with a solid tire insert, then
you must replace the whole wheel assembly. If you
have pneumatic tires, you can replace the tire or the
tube. Replacement wheel assemblies are readily
available through an authorized provider.
WARNING! The wheels on your power
chair should only be serviced by an
authorized provider or a qualified
technician.
WARNING! Be sure that the power to the
controller is turned off and the power
chair is not in freewheel mode before
performing this procedure.
WARNING! When changing the tire, remove
only the center lug nut and washer, then
remove the wheel. If any further disassembly
is required, deflate the tire completely or it
may explode.
See
figure 14.
To change the wheel:
1. Turn off the power to the controller.
2. Set the power chair up on blocks.
3. Remove the drive wheel nut and washer from the axle.
4. If you are changing a pneumatic tire,completely deflate it before removing the wheel.
