DOORS
FRONT DOOR REMOVAL
Door Removal Warning Label
NOTE:
When front doors are removed, the message
“Blind Spot Alert Temporarily Unavailable”
will display in the instrument cluster display.
Power Mirrors and Power Door Locks will also
be unavailable.
1. Roll down the glass window to prevent
any damage.
2. Remove the hinge pin screws from the
upper and lower outside hinges (using a
#T50
Torx head driver).
Hinge Pin Screw
3. Remove the wiring access door under the
instrument panel by sliding the plastic
panel along the door frame toward the
seats until the tabs are detached.
4. Pull up on the red locking tab to unlock
the wiring harness.
5. Push and hold down the black security
tab under the wiring harness, and lift the
harness into the open position.
6. With the wiring harness open, pull down
-
ward on the wiring connector to unplug.
Store wiring connector in the lower door
basket.
7. Remove the check screw from the center
door check (using a #T40
Torx head
driver).
8. With the door open, lift the door up and
away from the vehicle.
To reinstall the door(s), perform the previous
steps in reverse order.
REAR DOOR REMOVAL
1. Repeat steps 1-2 of the front door
removal procedure, and slide the front
seat(s) fully forward.
2. Pry open and remove the plastic wiring
access door from the bottom of the
B-pillar.
3. Unplug the wiring connector.
Wiring Connector
