Fayat DYNAPAC F1000T T4f, Руководство по эксплуатации и техническому обслуживанию

Страница: 186 / 263

E 4
2.4 Mounting extension parts
- Slide in the telescopic tube. When doing so, make sure that the drive of the auger gear is slid all
the way over the shaft end of the auger extension part and that the treads of the augers match.
- Remove the expansion screw (5). Then tighten the clamping screws (6). Finally tighten the
expansion screw by hand.
Before the clamping screws (6) can be tightened again, the expansion screw (5) must be sufficiently
turned back!
Otherwise, the telescopic tube cannot be safely clamped and the splined shaft ends break.
When clamped insufficiently, the telescopic tube can slide out of the support tube and can cause
severe injury or death as well as damage to the machine!
7
6
5
- Loosen the clamping screws (6) on the
support tube. Then turn in the center
expanding screw (5) to expand the clamping.
- Pull the telescopic tube out of the support tube
(7).
- Mount the required extension parts.
NOTE:
Observe the guide groove of the spline!
Make sure that the shaft end is clean!
- Install auger so pick end of auger is “IN TIME”
with the discharge of the main auger. This is
called “IN TIME” or “NORMAL” set up and is
used to prevent segregation (or separation) of
material. The auger pickup can be mounted
180 degrees away from the discharge. This
called “OUT OF TIME” and is used with large
or rounded stone to prevent segregation. If
already mounted and segregation occurs in
the mat at extension to main connection, move
the auger pickup 180 degrees from the current
position.