Fayat Group DYNAPAC SD1800C, Руководство пользователя

Страница: 392 / 472

F 50.18 8
Oil change:
A
The oil should be changed when at operating temperature.
- Place the end of the oil drain port hose
(C) in the collection container.
- Remove the screw cap with a wrench
and allow the oil to drain completely.
- Replace the screw cap and tighten
properly.
- Fill in the specified quality of oil
through the filler opening (B) on the
engine until the oil level rises to the
correct mark on the dipstick (A).
Changing the oil filter:
A
The new filter is inserted during an oil
change once the used oil has been
drained out.
A
The oil filter is located at the front end of
the engine. (Use the maintenance flap
for access)
- Loosen the filter (D) using a filter
wrench or filter strap and unscrew.
- Collect escaping lubricating oil.
- Clean the sealing face of the filter car-
rier with a clean, lint-free cloth.
- Slightly lubricate the seal of the new
filter before installing it.
- Screw the new filter in by hand until the seal makes contact and tighten with a
torque of 15-17 Nm.
A
After installing the oil filter, attention must be paid to the oil pressure display and good
sealing during the test run. Check oil level again.
C
D