Fayat Group DYNAPAC SD1800C, Руководство пользователя

Страница: 318 / 472

D 41.18 6
1.1 Starting the paver finisher
Before starting the paver finisher
Before starting the diesel engine and beginning operation, the following steps must
be performed:
- Daily maintenance of the paver finisher (see chapter F).
m Check the operating hours counter to determine whether further maintenance work
should be conducted.
- Check the safety devices and protective devices.
"Normal" starting
- Set the drive lever (13) to the centre position and the travel drive preselector (15)
to minimum.
- Insert the ignition key (11) in position "0".
A
It is impossible to start the vehicle if an emergency stop button (10) / (120) is depressed.
(Error shown on the display)
- Turn ignition key (11) to position 1 and wait for the preheat check (A) to go off.
- Press the starter button (12) to start the engine. Run the starter continuously for a
maximum of 20 seconds, then take a break for 2 minutes!
A
If the engine does not start and the error message indicator lamp (B) flashes, then the
electronic engine control system has activated the start inhibit.
To deactivate the start inhibit, turn the system off with the ignition key (1) for approx. 30 s.
m If the engine still has not started after two attempts, ascertain the cause!
f Do not use aerosol types such as ether as starting aid. This can cause an explosion
and lead to personal injuries.