Operation
> Twist the bottom of the lantern. Place the
batteries following the polarity signs.
Line up the notch and groove and twist
8
.
> Press the button
2
to turn on the lamp.
> Once the lamp turns on directly press the
control button to cycle through the light
modes: Natural white > Cool white >
Warm white > Candle light.
> In any mode, press and hold to move from
high to low brightness (flickering light
indicates lowest brightness).
Release button at desired brightness.
> Turnoff:
Press the control button after the
lamp has been in the same light mode for
at least 5 seconds.
Size
Ø 59 x 132 mm / Ø 2.3 x 5.2 inches
Weight
243 g / 8.6 Oz (with batteries)
IPX4:
Water resistant
Battery Type
4x AA-Alkaline batteries (included)
Bulb Type
3x 0.5W cool white Nichia LEDs
3x 0.5W warm white Nichia LEDs
Bulb replacement
LED never needs to be replaced.
WARNING!
• Do NOT look directly into the LED light for more
than a few seconds.
• Do NOT allow children to use LED light unless under
the supervision of an adult.
• Remove the batteries if not using the lantern light
for long period or before storage.
• The lantern could become extremely hot after
extended use. Switch it OFF or to Low Brightness
Level if the lantern becomes too hot.
• Provide adequate ventilation when the LED lamp
is on.
• Make sure the LED lamp has cooled completely
before touching its head.
Important
• Do not dispose the unit into fire or dismantle it
under any condition.
• Do not cause a short circuit. This may result in
permanent damage to the batteries.
• Using the product in extreme conditions may
affect the lifetime.
• Battery should always be stored in a cool and
dry place.
ENGLISH
SPECIFICATIONS
