523323 PUBLICATION DATE 2 OCT 2006.DOC
INSTALLATION AND MAINTENANCE MANUAL
3
2.3. IMPORTANT INFORMATION BEFORE INSTALLATION
FOR TRANSPORTATION AND STORAGE
IN CASE OF TRANSPORTATION AND STORAGE, WATCH COMPONENTS PROTRUDING FROM THE
CONTOUR LINE OF MACHINE (DOOR LOCKS ETC.), TO AVOID INJURIES.
•
Never push, pull or exert pressure on components protruding from the machine contour line (controls, door locks
etc.).
•
Make sure that these components are secured so as to avoid damages during machine manipulation and
installation.
•
In case of the machine transportation by the customer, follow the manufacturer's instructions for transportation,
handling and storage of the product. In case of transportation of machine by the customer the manufacturer is
not responsible for possible damage of machine in the course of transportation.
•
The ambient temperature of transportation and storage must be between -25°C - +55°C. Relative humidity must
be between 30% - 90% without condensation. In case of storage the machine in a free area it must be protected
against mechanical damage and weather condition factors.
FOR INSTALLATION
ELECTRICAL CONNECTION, EARTHING AND VENTING OF THE MACHINE, WATER INLETS AND
DRAINAGE MUST BE PERFORMED BY QUALIFIED PERSONNEL WITH A PROPER AUTHORIZATION
ACCORDING THE INSTALLATION MANUAL IN COMPLIANCE WITH LOCAL STANDARDS
(APPLICABLE ALSO FOR STEAM CONNECTION ON STEAM HEATED MACHINES).
•
Do not install the machine at places exposed to climatic effects or excessive humidity. The machine is not
designed to accept environment with sprayed water.
•
Any changes in the machine installations must be approved by dealer or manufacturer. Otherwise the
dealer/manufacturer is not responsible for possible injuries or damages. Interference and changes in the
machine construction are not allowed and the manufacturer refuses any responsibilities in such cases.
•
Define dangerous areas in the laundry room and do not allow people to enter if the machine is in operation.
MACHINE VERSION
•
This manual contain information for the whole series of rigid mounted machine types with filling of dry linen 10,
18 and 22 kg (25, 40 and 50 lb). Check, please, the type of your machine on the production label (located on
back of machine) and look for right information in the manual.
•
Machines are equipped with an electronic programmer MCB EC. The „OPL“ is a version with a programmer
controlled only by push-buttons.
•
The version with an electronic programmer is : 1 motor controlled by frequency inverter.
•
Starting of the machine comes by a start push-button.
•
Heating is provided by electrical heating elements.
•
Water valves are used for cold hard, cold soft and if necessary warm water.
•
The machine electrical connection is three-phases 3AC/380-415V+N. Machines in accordance to CE directives
are „CE“ marked on the machine name plate.
•
The machine design which fulfils The European Agreement requirements is stated in the name plate by the
symbol „CE“.
•
All machines types are produced according the EMC-directive (Electro-Magnetic-Compatibility). They can be
used in restricted surroundings only (comply minimally with class A requirements). For safety reasons there must
be kept the necessary precaution distances with sensitive electrical or electronic device(s).
•
The product fulfils the technical requirements for a product determined by the law no. 22 / 1997 of Digest of
Czech Republic.
•
The used electrical standard for concerned machines covered by this manual depends on the scope
of the considered standards in which the machine best fits. The chosen electrical standard is mentioned in the
declaration of conformity that is delivered by each machine.
