ENGLISH
2.2 Default parameters
Following is a list of default parameters for
programming, as shown in the “CONFIG.INI” file.
[Common]
P0.4 = €
P0.5 = 0000.50
P0.6 = 1
P0.7 = 00m00s
P0.8 = 00m00s
P0.10 = 1
P0.11 = 99999
Log = 1
[Service_01]
P1.2 = 00h00m30s
P1.3 = 00m02s
P1.4 = 00m00s
P1.5 = 00m00s
3 F
UNCTIONING
Before using the CT02, we suggest you
programme it according to the
indications found in the 2.1.
Following is a table with the functioning statuses of
the CT02.
CT02 Status
LED Status
Status of service
OFF
Off
Off
STAND-BY
Flashing every 2
seconds
Off
ON
On
On
PAUSED
Flashing every 0.5
seconds
Paused
To
ACTIVATE
service, place the prepaid card near
the CT02 reader area. The internal buzzer will emit
a
short beep
to indicate that the card has been
recognized, that the card's credit has been
updated, and that the relay or solenoid valve for the
programmed time has been activated.
A
PAUSE
can be activated in the following ways:
•
manually, by programming the P1.3 parameter
and connecting a button to the appropriate input;
•
automatically, by programming the P2.4 and
P1.5 parameters.
By placing the prepaid card near the CT02 reader
area, the internal buzzer will emit a
long beep
to
warn that
service has not
been activated
in
following situations:
•
if credit in the card is insufficient (less than the
base amount programmed with the P0.5
parameter);
•
if service is already activated and it is not
possible to increase the duration as the
accumulation of time (P0.6 parameter) has not
been enabled;
•
if the card is not valid (the system code of the
card is different from that of the CT02, or the
card has not been programmed, or is damaged).
4 C
REDIT
T
OTALIZER
WARNING: to verify the totalizer you must
have a USB stick containing the
“CONFIG.INI” file in which the parameter
“Log” is enabled (Log = 1).
WARNING: if you do not want the
parameters of the CONFIG.INI file to be
modified, you can cancel the
corresponding lines in the file, leaving
only the lines “[Common]” and “Log = 1”.
To verify the total credit:
open the CT02, insert a
USB stick into the outlet located on the board at the
back of the cover and wait until the second beep of
the internal buzzer sounds, indicating the creation
of the “
CTLOG.TXT
” file.
The file should look as follows, with the total credit
managed by the CT02, as well as the software
version, indicated.
[Log]
Totalizer = 01234567,89 €
Software version = 1.03
Each time a USB stick is inserted, the system will
update the file.
To zero the credit:
disconnect the CT02 power
supply; hold down the programming key located at
the bottom right hand side of the board attached to
the CT02 cover; reconnect the power supply and
then wait for the second beep of the internal buzzer
to sound, indicating the modification of the
configuration parameters.
00182-M07-01-ML User manual CT02
Pag. 6 / 24
F
AVERO
E
LECTRONIC
D
ESIGN
