FAURE FWG 3125, Руководство пользователя

Страница: 18 / 24

• Refit the emergency emptying cap into the filter and
screw the water inlet hose back.
• When you intend to start the machine up again,
make sure that the room temperature is above 0°C.
Emergency emptying out
If the water is not discharged, proceed as follows to
empty out the machine:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has cooled down;
• open the pump door;
• place a bowl on the floor. Remove the emergency
emptying cap from the filter. The water should drain
by gravity into the bowl. When the bowl is full, refit
the emergency emptying cap into the filter. Empty
the bowl. Repeat the procedure until water stops
flowing out;
• clean the pump if necessary as previously descri-
bed;
• screw the pump cover again and close the door.
Important! Every time you drain the water through the
emergency emptying hose you must pour 2 litres of
water into the main wash compartment of the detergent
drawer and then run the drain programme. This will
activate the
ECO Valve device avoiding that part of the
detergent remains unused at next washing.
Installation
Unpacking
All transit bolts and packing must be removed before
using the appliance.
You are advised to keep all transit devices so that they
can be refitted if the machine ever has to be transported
again.
After removing all the
packaging, carefully lay
machine on it's back to
remove the polystyrene
base from the bottom. Remove the power sup-
ply cable and the hoses
from the hose holders on
the rear of the appliance.
Unscrew the three bolts. Slide out the relevant
plastic spacers.
Fill the smaller upper hole and the two large ones
with the corresponding plastic plug caps supplied in
the bag containing the instruction booklet.
Positioning
Install the machine on a flat hard floor. Make sure that
air circulation around the machine is not impeded by
carpets, rugs etc. Check that the machine does not
touch the wall or other kitchen units. Level the washing
machine by raising or lowering the feet. The feet may
be tight to adjust as they incorporate a self locking nut,
but the machine MUST be level and stable.
Any necessary adjustment can be made with a span-
ner.
Accurate levelling prevents vibration, noise and dis-
placement of the machine during operation. Never
place cardboard, wood or similar materials under the
machine to compensate for any unevenness in the
floor.
18