FAURE FWG 3125, Руководство пользователя

Страница: 19 / 24

If necessary, check the
setting with a spirit level.
Water inlet
Warning! This appliance must be connected
to a cold water supply
Caution! Before connecting up the appliance to
new pipework or to pipework that has not been
used for some time, run off a reasonable amount of
water to flush out any debris that may have collected
Caution! Do not use the hose from your previous
appliance to connect to water supply.
Connect the hose to a tap
with a 3/4” thread. Al-
ways use the hose sup-
plied with the appliance.
35°
45°
The other end of the inlet hose which connects to the
appliance can be turned as showed in the picture.
Do not place the inlet hose downwards. Angle the
hose to the left or right depending on the position of
your water tap. Set the hose correctly by loosening
the ring nut. After positioning the inlet hose, be sure
to tighten the ring nut again to prevent leaks.
Caution! The inlet hose must not be lengthened.
If it is too short and you do not wish to move the
tap, you will have to purchase a new, longer hose
specially designed for this type of use.
Water drainage
The end of the drain hose can be positioned in three
ways:
Hooked over the edge
of a sink using the plas-
tic hose guide supplied
with the machine.
In this case, make sure the end cannot come un-
hooked when the machine is emptying. This could
be done by tying it to the tap with a piece of string or
attaching it to the wall.
In a sink drain pipe branch . This branch must be
above the trap so that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm. The end of the
drain hose must always be
ventilated , i.e. the inside
diameter of the drain pipe must be larger than the
outside diameter of the drain hose. The drain hose
must not be kinked.
19