Fatshark 8 RC Vision Systems
Futaba Radio setup.
Note: Head tracker only works with higher end Futaba radios that support
selective student channel mixing. Connect Data cable and turn on radio.
-
Enter TRAINER menu and assign desired head tracking channels to
FUNC (must be set on FUNC). Default is CH 5//6.
-
Individual servo direction can be set in REVERSE menu (reverse
not available for 7C users, must reverse direction in HT menu).
Head Tracker Operation
- Head tracker will automatically start tracking upon powering up headset.
- Look forward and level then press the Head Tracker button to center (note,
on 1
st
press HT may drift off momentarily during calibration cycle, hold head
steady until camera returns to center).
- Repressing the HT button during use re-centers the camera position.
- External interference (from RC controller, other devices) may temporarily
cause errant readings in the magnetic sensor and cause drift.
If error
between camera and direction your head occurs, hold your head steady in
one
position
and
head
tracker
will
autocorrect
to
that
position.
After auto correction, continue to use normally.
Head Tracker Center Hold Function
To pause and hold head tracker in center position; hold down the HT button
for 4 seconds (4 seconds to pause, 4 seconds to reactivate).
Internal receiver (2.4G/5.8G)
Insertion
