Fatshark 5 RC Vision Systems
Headset Operation
Controls
Brightness/contrast control:
pressing left and right increases/decreases
display contrast. Press forward/back increases/decreases brightness.
Channel select:
Pressing channel up/down buttons will cause the channel to
incrementally increase/decrease. Audio beep on channel change. A long
beep sounds on channel top and bottom limits.
Because 2.4G and 5.8G receiver modules share same channel control but
have different channel settings, refer to following channel mapping chart:
Headset channel
5G8 channel
2G4 channel
1
1
1
2
2
2
3
3
N/A
4
4
3
5
5
N/A
6
6
N/A
7
7
N/A
8
7
4
Low battery warning:
Audio warning if input voltage drops below 6.8V
Volume control:
each press of button increments volume up or down.
Standard earphones can be used with the Dominator.
Head tracker:
See section under accessories
RX power switch:
The RX module power is independently controlled via this
switch. If a module is inserted, but desired video source is via the AV cable;
the RX module needs to be turned off to avoid image conflict.
AV Cable Pinout
Ground Video
AudR
AuL
RCA Connector
: Yellow: Video, White: Audio Left, Red: Audio Right
Recording Video
Connect AV cable to AV out port on right side of headset. Connect recording
device to cables and set up as per manufacturer directions.
Note: Cables pins are not all the same (see above chart), be sure to connect
to headset using the included cable.
