INSTALLATION INSTRUCTIONS
STEP 1
Park the trailer on a flat level surface, such as a driveway or
parking lot. Chock both sides of the trailer, and set the tow vehicle
parking brake. Keep the trailer coupled to the tow vehicle, or place
jack stands under the trailer tongue to support the trailer without
using the tongue jack. Disconnect the trailer plug, safety chains,
and safety breakaway cable from the tow vehicle and move them
out of the way.
Never exceed maximum 4,000 lb lift capacity.
Do not install the 2-1/4" model on a 2” jack (1-3/4" inside tube).
Install FLIP jack foot with trailer parked on level ground
both side-to-side and front-to-back.
STEP 2
Extend the jack slightly.
Inspect the jack foot
attachment hole at the
bottom of the inner tube
of the jack. If it is drilled
perpendicular to the trailer,
and between 1/2” and 1-1/4”
from the bottom of the tube,
no jack modifications are
required to install your FLIP
jack foot.
If the hole is NOT oriented correctly, is too low or too high, or if you
are installing your FLIP foot on a square jack, go first to STEP 3 to
prepare the jack, then continue with the installation of the FLIP jack
foot.
Hole at right angle to trailer and 1/2" to 1-1/4"
from bottom of tube needs no modification.
Содержание FLIP 88-00-4500
Страница 1: ...INSTALLATION AND OPERATION INSTRUCTIONS...