FASTERHOLT FM4550, Руководство пользователя и каталог запасных частей

Страница: 25 / 96

25
Fault Iocalisation.
?
The turbine can not start by pressing START. Pre-and post-irrigation can not take place.
Answer:
Magnet for stop-sensor is not on its place, or cable or sensor is damaged.
Stop sensor: The mark must be on when the magnet is on place, and it disappears when the magnet is re-
moved. See menu 3.
A damaged cable can be repaired but absolutely watertight. At least encapsulated in epoxy.
But a new sensor and cable is recommend.
If pressure sensor is used there must be pressure on the water. The mark for pressure must be on.
?
No digits in the display.
Answer:
Battery interrupts. Fuse inside the box is blown. The fuse is for wrong connection of + and -
From the factory there are an extra fuse on a single fuse-holder on the printed circuit.
Fuse 5 A. Battery electric voltage 12 V. See menu 2.
?
The clock shows 00:00.
Answer:
If the power has been interrupted the clock will go to zero. Therefore instead of showing the finishing time it is the
number ofhours and minutes to the irrigator is finished that is shown. Ifthe clock is set the time to the irrigator
has finished will be show. See setting the clock.
?
Distance meter is not correct and the speeds not correct.
Answer:
See after damaged cable or sensor. The 2 marks must during pulling out the tube appear in order from the
lefl as foliowing: The first appear the second appear the first disappear the second disappear. During retraction it
must go in opposite order. See menu 3 speed sensor.
?
Only maybe the half or 2/3 ofthe real length is counted up.
Answer:
The stop mechanism can be activated a short time by hopping ofthe tube or ifthe windings around the drum are
losing. It can cause the magnet removed from the stop sensor a short moment. It will set the counter to zero.
In spite of the meter of the tube is not correct the irrigator will run to the end and stop normal. But incorrect
speed depends of the incorrect registration of the actual layer. If wanted the correct number of metre can be set
in. See CONSTANT no 7.