FASTERHOLT B2, Руководство пользователя и запасные части, Страница: 15 / 84

15
Maintenance
Important:
After the first 25 operating hours:
1. Retighten the machine.
2. Adjust the chains and V-belts.
3. Adjust the hose guide.
After 25 hours of operation, it may be necessary to adjust the hose guide. The hose guide must lay each hose turn tightly up against the
previous hose turn (see Fig. 5). If the situation is as shown (Fig. 6), it will be necessary to adjust the hose guide.
Adjustment:
Stop the machine, loosen the chain tensioner (Pos 1) and lift the chain off the chain wheel. You can now pull the chain back or forth by
hand, so the hose guide will move to either side.
Move the hose guide in this way so that the hose section that is engaged comes onto the drum and overlaps the rewound hose by 5-10
mm. When this condition is reached, put the chain back on the chain wheel and tighten it. The hose guide is now correctly adjusted. The
adjustment should be made when the hose is wound on the inner layer. Turn the drum a few times to check that the hose is fitted correctly.
Lubrication: (after 25 operating hours) and weekly thereafter
Lubricate the sliding bushing on the drum inlet pipe (Fig. 4, Pos 4).
Lubricate the cross track shaft.
Lubricate the guide rail for the hose guide.
Lubricate the main bearing on the drum.
Lubricate the wheels on the gun trailer.
Lubricate the turntable.
We recommend Molykote grease for lubrication of the above parts.
Lubricate chains with water-repellent oil.
Note: Stop lubricating the sliding bushing in the inlet bend of the hose drum when there is a slight increase in pressure in the grease gun.
Annual maintenance
Lubricate the sliding bushing on the drum inlet pipe (Fig. 4, Pos 4).
Lubricate the cross track shaft.
Lubricate the guide rail for the hose guide.
Lubricate the main bearing on the drum.
Lubricate chains.
Lubricate the wheels on the machine and gun trailer.
Lubricate the turntable.
We recommend Molykote grease for lubrication of the above parts.
Note: Stop lubricating the sliding bushing in the inlet bend of the hose drum when there is a slight increase in pressure in the grease gun.
Lubricate the damper in the three-way valve with water-repellent grease (KLOBER NBU 30 PTM.)
Change oil in the gearbox. Oil type Castrol EPX 80/90 gear type or equivalent.
Check the air pressure in the wheels: Machine = 38 psi - 2.75 bar
Gun trailer = 14 psi - 1 bar