FASTERHOLT B2, Руководство пользователя и запасные части, Страница: 13 / 84

13
Manual stop
The machine can be stopped either at the pump or by pressing “STOP” on the computer.
If the hose is to be rewound after stopping, see the section PTO rewind.
Safety stop
The safety bar on the rewind side of the machine ensures that the machine stops when the hose is wound incorrectly. The safety cable
ensures that the machine stop will in case of computer failure. Adjust the safety bar until it is 1 cm from the drum edge. Adjust the cable so
it is tight when the three-way valve is fully open (max. speed.)
Important:
When starting for the first time, check that the safety bar and cable are adjusted correctly.
Supervision
The computer monitors the machine to ensure that it stops correctly if the rewind stops prematurely.
E.g.
1. Machine is not in gear
2. Foreign objects in the turbine
3. V-belt is too slack
PTO rewind
The machine is equipped with a PTO rewind, which is used to manually wind up the hose if irrigation is stopped before the gun trailer is
inside the machine.
The PTO rewind is connected to the tractor via a PTO shaft (power transmission shaft.)
1. The coupling lever must be disengaged before starting to rewind.
2. Apply the tractor’s hand brake.
3. Max. PTO speed is 200 rpm.
4. Stop the PTO rewind approx. 2 m before the gun trailer is inside the machine and use the PTO crank handle (located in the
cover) for the last section.
Important:
Remove the PTO crank handle during operation.
The PTO shaft must not be on the machine during operation.
The machine must be supervised when the hose is rewound onto the drum via the PTO rewind.
Warning: If the machine is stopped during rewind, the hose is in tension and the drum may run backwards when the clutch lever
is released.
It is forbidden to climb on or under the machine during operation.
Gun trailer
The gun trailer can be adjusted with different track widths by loosening the tensioning lever (Fig. 8, Pos 1). The gun trailer can also be
displaced sideways by loosening the two tension bars (Fig. 8, Pos 2).
If the gun trailer does not follow the same track during rewind as during unwind, loosen the centre bolt on the steering wheel (Fig. 8, Pos 3)
and move the wheel axle back and forth on one side by turning the steering wheel.