(619) 665-2077
Step 7. Plug the pump in
:
Set pump toggle switch to the
3
setting for the highest speed.
Step 8. Plug the pump in
:
Plug the pump into a properly grounded 110 vAC outlet.
Step 9. Test pump operation
:
Turn on any hot water faucet in the house to start the pump. Turn off the faucet to stop the pump
(assuming that the
Bridge Valve
has not been installed yet).
Note
: If the
Bridge Valve
has been installed the pump will continue to run until 95°F water
reaches the sink where the
Bridge Valve
is installed. The temperature sensor in the
Bridge
Valve
will shut off and the water will stop flowing (unless a hot water faucet is open).
Bridge Valve Installation
Location
:
The
Advanced Bridge Valve
should be installed under the kitchen or bathroom sink that is the
farthest fixture from the water heater. Branched plumbing systems will need an
Advanced
Bridge Valve
at the end of each line. Additional
Advanced Bridge Valves
are available at
Installation:
1.
Turn off water to the house and drain the water from the pipes.
2.
Turn off both the hot and cold angle stops (valves) below the sink.
3.
Disconnect existing hot and cold water supply lines from the angle stops and replace
angle stops with custom angle stops (see below).
4.
Attach new stainless steel advanced 1/2" x 1/2" supply lines to angle stops.
Note
: Do not use Teflon tape or pipe dope on
Advanced Bridge Valve
connections.
5.
Attach other end of advanced supply lines to the appropriate "Cold Water In" and "Hot
Water In" ports of the
Advanced Bridge Valve
. Tighten finger tight plus a quarter turn
with a wrench.
