Fastback 802, Инструкция по эксплуатации

Страница: 27 / 28

27
Problem
Solution
Cause
Drips coming out of the
spout (4) at the end of
dispensing This is not a fault. It is normal for a few drips to come out at
the end of dispensing
Coffee dispensing does
not stop even if you press
the dispensing symbols (2-
3) Faulty components Take the plug out of the socket and apply
to the service centre.
The machine has not been
properly rinsed after descaling Rinse the machine again
The coffee dispensed has
an acid taste
Use of expired capsules Check the capsule expiry date
The capsule is not
ejected correctly
Capsule stuck in the infusion
group
Close the lever (1) and open it again slowly
Press the symbol (2) and slowly open the
control lever (1) while the water is being
dispensed.
Capsule container (6) full
Make sure that the capsule container drawer
(6) does not contain too many old capsules,
preventing ejection of the used capsule; empty
it.
If the fault persists, apply to the service centre.
The capsule is not held in
the infusion group and falls
directly into the capsule
container (6)
Control lever (1) not completely
open
Completely open the control lever (1) so that
the capsule support comes out of its housing;
recover the unused capsule from capsule
container (6) and insert it again. If the fault
persists, apply to the service centre.
After having inserted the
capsule in the infusion
group, you cannot close
the control lever (1)
Capsule not aligned with
the infusion group Open the control lever (1) again and then
close it completely. If the fault persists, apply
to the service centre.
The coffee dispensed by
the machine is cold Faulty boiler Apply to service centre
Capsule container (6) full Make sure that the capsule container drawer
(6) does not contain too many old capsules
and cannot take any more, then empty it.