Fastback 802, Инструкция по эксплуатации

Страница: 22 / 28

Starting up/heating
• Connect the machine by inserting the plug in the power
socket.
• Switch on the machine by pressing one of the symbols (2)
or (3) or the 2 symbols (2) and (3) simultaneously for the 2-
Dose model. For the 1-Dose model, press the symbol (3)
(Fig.4) . The symbols (2-3) will flash intermittently until the
temperature is reached; when the symbols (2-3) are lit with
a fixed light the machine is ready for use.
• Each time it is switched on, when the machine reaches the
operating temperature, the pump is activated for 1 second
to eliminate cold water from the internal circuits.
• When the machine is heating (with symbols 2-3 blinking) it
cannot dispense beverages.
Energy saving function
The machine is provided with a system that enables it to pass
to energy saving conditions (OFF) after it has been switched
on for a certain time without being used.
If the machine remains on without being used, it switches off
automatically after about fifteen minutes.
To use the machine again, press a dispensing symbol (2-3) and
wait for it to heat up: the dispensing symbols (2-3) will blink
intermittently until the temperature is reached; when the symbols
(2-3) are lit with a fixed light the machine is ready for use.
(Fig.4) .
At the first use, or if the coffee machine has remained unused for a long time, the internal circuits
must be rinsed following the procedure described below:
• Check that there are no capsules inside the machine and that there is water in the tank (8); switch
on the machine by pressing one of the symbols (2-3) or simultaneously the 2 symbols (2-3) for
the 2-Dose model. For the 1-Dose model, press the symbol (3)
(Fig.4)
• The symbols (2-3) will flash intermittently until the temperature is reached; when the symbols (2-
3) are lit with a fixed light the machine is ready for use. Place a cup on the grid, then press the
dispensing symbols (2-3), depending on the model, the machine, dispenses water
(Fig. 5)
; press
the symbol again when the desired amount of water has been reached. The rinsing operation
is ended when at least three cups of water have been dispensed.
Rinsing the machine/internal circuits
Fig.5
22
ATTENTION:
To save energy, the machine automatically switches
off when not in use for more than 15 minutes.
Switching off the machine
The machine can be switched off by simultaneously pressing
and holding down for 5 seconds the symbols (2-3) for the 2-
Dose model or the symbol (3) for the 1-Dose model.
(Fig.4)
1-DOSE
2-DOSE
3
2
3
2
3
Fig. 4