Fast AG SOLUTIONS 963P, Руководство пользователя

Страница: 75 / 81

TROUBLESHOOTING
TROUBLESHOOTING 3PT Sprayer 963P / 963PTF Page 75
TROUBLESHOOTING
Problem Cause Solution
System loses pressure.
Filter screen plugged Clean chemical line screens
Pump worn
Check and repair or replace
pump
Faulty suction hose
Check for collapsed suction
hose. Replace hose
Faulty regulator Replace regulator
Hose leaking Tighten hose or replace hose
Sprayer pressure too high.
Return hose plugged Clean or replace hose
Faulty pressure sensor
Calibrate sensor. Replace as
required
Faulty regulator Repair or replace valve
Wrong agitation valve setting
Open agitation valve slightly
until pressure goes to required
range
Tip too small for volume
Check Manufacturer’s tip chart
for proper size
Chemical system pressure
too low.
Return hose plugged Clean or replace hose
Faulty pressure sensor
Calibrate sensor. Replace as
required
Faulty regulator Repair or replace valve
Wrong agitation valve
Close agitation valve slightly
until pressure goes to required
range
Check valves or screens
plugging.
Dirty water
Flush and clean the system.
Use clean water
Poorly mixed chemicals
Mix chemicals more slowly.
Follow mixing instructions
High spray drift.
Boom set too high Lower boom
Too windy Wait until wind dies down
The pump does not draw
Water.
Pump is airlocked Bleed air from pump
Suction line is plugged or
collapsed
Examine suction line. Replace
as required
Pump faulty Replace pump
Pressure reading fluctuates.
The pump is sucking in air
through the intake or air has
Examine the suction hose and
make sure it is firmly secured.