Fass Titanium Series, Руководство по установке

Страница: 9 / 13

10
Step 2:
Prepare Suction and Return Line
a.
Mark location on the filler tube that allows you to install RM-1002. Cut
tube.
b. Position RM-1002 with the junction pipe aiming to outside of bed. Connect
rubber and RM-1002 using both HC-1004‟s but do not tighten.
c. Using a HC-1001 connect FL-1001 to the junction of RM-1002.
d. Disconnect factory suction line by pinching in on the side tabs. Thoroughly
clean this suction port .
Caution: make sure there is enough tube on each side of the cut to insert the RM-1002 and to place the hose
clamps.
e. Insert QD-1001 and clamp into opposite end of fuel line. Oil O-rings inside
QD-1001 and slide onto factory suction port until you hear a click. Loop
fuel line over frame. Do not cut at this time.