Fasep 2000 srl
Rev. 1.3
Balatron B110, B210: User
’s Manual
15 July 2013
8-1
8
SPECIAL FUNCTIONS MENU
8.1
Enter in the special functions menu
Switch on the wheel balancer. Press
<SET>
before
SOF
X.XX will disappear.
CAL
Calibration of wheel balancer
CAL tSt
Control of the calibration of electronic sensors
CAL rod
Calibration of electronic input sensors
LED TST
Test Led
SEn Sor
Diagnostic of sensors
StA tiS
Statistic about the use of machine
USr Set
User setup
tEc Set
Technical Setup
Ser nuM
Serial number
Act Cod
Inserting Activation Codes
8.2
Diagnostic program of sensors
Switch on the wheel balancer. Press
<SET>
before
SOF
X.XX will disappear. Select
Sen Sor
and press
<SET>
.
rPM
Balancing speed
PS1
PS1 voltage
PS2
PS2 voltage
tO
Encoder is in the zero position
PoS
Angle of position sensor(from 0 to 255)
dIS
Value of distance sensor
dIA
Value of diameter sensor
8.3
Statistic program
Switch on the wheel balancer. Press
<SET>
before
SOF
X.XX will disappear. Select
Sta tis
and press
<SET>
.
tOt
Total number of spin
SUC
Percent of runs with a good result
c11 0s
Percent of wheels with diameter <11"
from
11
to
17
Percent of wheels with the indicated diameter
]17 0s
Percent of wheels with diameter >17"
CAL
Number of calibrations
8.4
User Setup
Switch on the wheel balancer. Press
<SET>
before
SOF
X.XX will disappear. Select
USa SET
and press
<SET>.
ScA LE
Set 1 or 5 grams step (0.05/0.25 ounces).
Cut oFF
Set minimum weight to be displayed
Uni Out
Unit of measure for the width (0=inch, 1=millimeters).
Uni Umb
Unit of measure for the weight (0= grams, 1=once).
Fin AL
Display of final (0 = normal, 1 = blink, 2= Go OD).
biP
Enable/Disable beep in position
EME StP
Motor brakes in case of emergency stop (
On
or
OFF
) (
OFF
: motor power is cut).
Cou Er
OFF
= safety cover is not installed;
On
= the motor starts only if the safety cover is closed;
Aut
= closing of safety cover the motor starts automatically
rod in
Enable/Disable distance input system.
rod out
Enable/Disable width input system
STE P
Increase distance/width measure.
PNE U
Enable/Disable PL system.
SCR EEN
Screen saver selection from 1 to 5 (0 = disable).
VOI CE
Enable/Disable voice system.
Snr
Sensibility to external vibration.
Tim er
Input system speed.
Fas t
Enable/Disable fast cycle
APS
Enable/Disable automatic position system.
ADM IN
Enable/Disable Admin mode.
OPT
Set minimum tire matching level.
rES Et
Load Factory Setup.
