Farymann Diesel 15D Series, Руководство по ремонту

Страница: 17 / 76

III. ENGINE REPAIR
18
Loosen the high pressure line at the injector
in the same way.
(Figure 8)
9. Fuel injector
Remove the two hex nuts and their
lockwashers from thr injector clamp. and pull
out the injector. If the injector sticks in the
hand, use a soft faced hammer and tap
slightly on the injector. Do not use too much
force, as this may damage the injector.
Attention: Undder the injector a special
packing washer is located which must
also be removed.
10. Cylinder head
Remove the two locknuts and washers (1)
holding the protection tubr retaining spring.
Next loosen the four cylinder head nuts (2).
(Figure 10)
Drive out the rocker arm bolt with a drift pin
and a hammer. Remove the rocker arms and
push rods.(Figure 11)