Operation Manual
FarSounder, Inc.
F31552 (Rev. 3.8.0)
Page 10 of 69
Amphenol
Plug
(97-3106A-24-7P)
Cable
Subconn (BH16FSS)
A
RG59 Center
1
B
RG59 SHIELD
2
N
12 AWG YELLOW
3
P
12 AWG ORANGE
4
C
16 AWG BLACK
5
D
12 AWG BLUE
6
E
16 AWG WHITE
7
F
16 AWG RED
8
G
CAT5 GREEN
9
H
CAT5 WHITE/GREEN
10
I
CAT5 ORANGE
11
J
CAT5 WHITE/ORANGE
12
K
CAT5 BLUE
13
L
CAT5 WHITE/BLUE
14
M
CAT5 BROWN
15
O
CAT5 WHITE/BROWN
16
Table 2. FarSounder Cable Pin Mapping
Important
The outer braded shield of the cable is a structural component only. There is no need to connect
it to ground.
Wet End Preparation
The wet end of the cable is terminated with a Subconn BH16MSS connector. This connector is molded
onto the cable at the factory and cannot be serviced by the user. This connection can be mated in a wet
environment or underwater. The wet end connector is approximately 2.4 inches (6 cm) in diameter.
Warning
This connector can be mated and un-mated underwater as long as the Power Module is
switched off. If this connector is to be left un-mated in a wet environment or underwater, it is
necessary to protect it using the supplied Connection Cable End Cap.
Figure 9. Remove connector cap from cable
