5
Connections
This page outlines how different sources and
displays can be connected to the DVP3000.
Because of the high performance of the
DVP3000 it is very important to use the highest
quality cables possible, for both input and output
signals.
Both the RGB BNC and the D15 Monitor output
connections are active at all times and can run
two displays simultaneously.
To avoid AC ground loop problems, the source
equipment, DVP3000 and projector should all be
running on the same AC power line (one
correctly rated for the power requirements).
Source Inputs
1.
S-Video (Y/C) sources such as DVDs,
Satellite systems, S-VHS tape decks (when
using S-VHS tapes only), Hi-8 tape decks.
2.
Composite video sources such as Laserdisc
players, cable TV, VHS tape decks, 8mm
tape decks.
3.
Interlaced Component video sources such
as DVDs and professional tape decks.
Progressive Component signals from DVDs
are also connected here.
4.
High scan rates sources such as HDTV and
computers as a pass-through to the
projector.
Outputs
5.
D15F connector for use with computer
monitors or to a second display device.
6.
BNC connectors for main output to display
devices. For YPrPb outputs use:
Red =
Pr
Green =
Y
Blue =
Pb
Note: If HDTV or Computer signals are to be
used, the projector must have separate H & V
sync cables installed.
Control
7.
12V trigger to activate automatic screen
relays.
8.
IR receiver connection allows for use with
external IR receivers so unit can be installed
behind walls.
9.
RS232 D9F connection for use with RS232
control systems
10.
AC Power connection.
Installation
1
2
3
4
5
6
7
8
9
10
