Faro
STEAM
Pag. 8 of 10
3.4.6
Sanix
Sanix contains 0.5 lt of liquid and must be used at speed 3.
The flow of steam in the upper part generates a venturi effect
and the liquid is delivered together with the steam.
Different detergents can be inserted inside Sanix depending on
the result you want to achieve.
The liquid is slightly superheated in contact with the steam,
when it reaches the surface it will be almost at room
temperature.
Sanix creates a jet of about 1 meter with a diameter of 30 cm.
Use it at a distance of about 50/70 cm from the surface in order
to have an homogenous distribution.
3.5
Using the Steam Generator
3.5.1
Before Cleaning
Warning
The steam out of the lance has a temperature of about 130 ° C. For cleaning heat
sensitive materials, keep the lance at a minimum distance of 10-15 cm from the target.
Avoid the use of steam on electric electronic appliances or very sensitive materials.
When the appliance is just switched on, condensing water or gases may form in contact with cold
accessories.
Before use, adjust the steam to power 2-3 (§3.2) and let the appliance run for a few seconds.
Never use the appliance to clean non-heat-resistant materials.
Never leave the steam switch in position 3 for a long time . The normal position 2 is sufficient and
consumes less energy.
If the soil is hard, the first phase will take more time and more cloths could be needed for the normal use of
the steam generator.
3.5.2
After Cleaning
Always turn off the boiler heating switch.
Drain all the steam from the boiler. Otherwise the safety cap will not open.
Remove the power plug.
Before storing the appliance, wait until it has completely cooled down.
If you will not use the appliance for 2 weeks, empty out any water left in the boiler, as described in the
"Lime scale Removal" section § 4.1.
