INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ / SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA / SICHERHEITSHINWEISE /
VEILIGHEIDSINSTURCTIES / INSTRUZIONI DI SICUREZZA /
ΟΔΗΓΊΕΣ
ΑΣΦΑΛΕΊΑΣ
/
ИНСТРУКЦИИ
ПО
ТЕХНИКЕ
БЕЗОПАСНОСТИ
ovni
faro - 24
refs. 33135, 33136, 33137
1- Locate ceiling joist where fan is to be mounted, being sure location agrees with the requirements in the minimum
clearance safeguards section of the guide. Wood joist must be sound and of adequate size to support a 35- Ib load.
2- If not already present, mount a UL listed outlet box marked “suitable for fan support” following the instructions
provided with the outlet box. The outlet box must be able to support a minimum of 35 Ibs.
3-Attach hanger bracket to outlet box using 2 machine screws provided with the outlet box(Fig.1)
Hanger brackek
Spring washer
Screw
Fig.1
INSTALLING THE FAN
ATTACHING DOWNROD, CANOPY AND COLLAR COVER (FIG.2)
1.
Remove ball from downrod by loosening set screw in the side of the ball. Slide ball down and remove ball pin;
remove ball.
2.
Feed the 3 wires from top of fan through either end of downrod and set end of downrod into mounting collar.
3.
Insert downrod pin through holes in mounting collar and downrod; slip cotter pin through small hole in end of
downrod pin in place.
4- Tighten security screws against downrod using a large flat blade screwdriver to ensure a tight fit against downrod.
NOTE: Fan has 6 feet of hook-up wire in case you are using an extension downrod. Wires can be cut so only 8 inches
or so extend beyond the top of the downrod to make the electrical connections easier and safer.
5- Feed wires through collar cover and slide collar cover over downrod to top of fan. Connect wires (A) from top of fan to
wires (B) in collar cover by snapping two halves of wiring harness together. ( Align 2 ridges and grooves inside
connectors- they will only snap together one way.) Secure collar cover to downrod with set screw on top edge of collar
cover.
6- Feed wires through canopy and slide canopy over downrod to lay on top of collar cover. It will be attached to ceiling
later.
7- Feed wires throught ball and slide ball over downrod, past hole in end of downrod. Insert ball pin (removed in Step 1),
slide ball up and tighten ball's set screw to secure ball in place.
Canopy
Downrod
Cotter Pin
Set screw
with Hex nut(2)
Yoke Cover
Assembly
Cross pin
Yoke
Fan
Assembly
Canopy
Yoke Cover
Assembly
Yoke
Fan
Assembly
Downrod
Assembly
Downrod
Assembly
Yoke Cover
Assembly
Canopy
Fan
Assembly
Fig.2