1.
Using measurements from the table above, measure & mark the height (Y). Measure
from the center of the bearing, to height (Y), and mark. We recommend using masking
tape to make marking the height easier. Use a framing square to trace the height (y)
across the masking tape on the clean grain elevator.
It is very important to install the optical sensors directly opposite each other, so take
care with marking the mounting holes.
Shown: line drawn on tape to mark exact height of sensors from bottom bearing.
2.
With the height (Y) marked across the clean grain elevator, measure & mark the
distance (X).
Shown: marked sensor hole location (x) from of the back of the clean grain elevator.
3.
With height (Y) and distance (X) marked, use a center punch to mark the location for
drilling the sensor mounting pilot holes.
