15
Revision date: 05.01.19
Assembly Instructions
There are different ways to keep the dripper lines anchored inside
each bucket. In the example shown on this page, the 110413
dripper weights are used.
After setting all buckets in place with the bucket drain fitting
inserted into the return line, attach a 110413 dripper weight to
each dripper line.
Next, simply drape the line over the bucket lip and into the bucket.
There are two (2) lines for each bucket.
The depth of the dripper weight can be adjusted once the buckets
are filled and planted. The next page shows filling the buckets.
ATTENTION:
Before filling and planting the buckets, it is best to
test the nutrient supply and return lines. Add water to the reservoir,
verify that all buckets and lines are in place, and plug in and turn
on the pump.
Check all drip lines to verify
that water flows out of the
weights and into the buckets.
Next, verify that the water
flows out of the buckets and
into the return line.
Finally, check the outlet of
the return line to verify that
water flows freely into the
reservoir. Adjust the buckets
and drip lines as needed to
achieve the best results.
Check all fittings to ensure
they are operating as
designed.
Turn off the pump
and continue with the
suggestions on the following
pages if these apply.
3
2
4
1
5
6
12