F a r m T e k ®
If you have any questions, please call
us toll free at 1-800-FARMTEK.
Fabric Clip
(#CC6211)
Fabric Staple
(#CC4432)
STEP 2
INSTALL THE COVER FILM
Secure the cover film to the assembled frame using
CC6211 fabric clips. Install fabric clips on the end rafters
only.
Complete these steps.
1. With assistance, carefully pull the cover over the frame
and center it front-to-back and side-to-side.
2. Using CC6211 fabric clips, secure the cover at the
peak on the front side of an end rafter and continue
working down the end rafter to secure the main cover.
Clips simply snap onto the rafter to hold the cover film.
NOTE:
Use half of the fabric clips on one end rafter
and the other half on the remaining end rafter.
3. Once the cover film is attached to one end rafter, move
to the remaining end rafter, carefully stretch the cover
film in place, and secure it as previously described.
NOTE:
Have an assistant hold the first end rafter while
the cover film is pulled over the frame and toward the
other end. Do not pull the cover film too tight; doing so
may cause the end rafter to lean toward the middle of
the frame.
4. Secure the cover film sides using the CC4432 fabric
staples. Stretch the cover film down to the ground
and push staples through the film and into the ground
along each side of the frame.
Use half of the staples to
secure each side.
NOTE:
The shade
cover shown in these
photos will differ from
the actual film cover
included with your
row cover kit. Please
call customer service
at 1-800-245-9881
to purchase shade
material, or to learn
about the benefits of
using shade material.
