FARMTECH T-DCBM-4, Руководство пользователя

Страница: 7 / 36

8
1-Upper hitch arm
2-Left hanger arm
3- Stretchning chains
4-Lower hitch arm
5-Right hanger arm
Pic.10 Connecting the machine to the tractor
Connecting the machine to the tractor:
Firstly connect the lower non adjustable arm then adjustable arm at the end connect upper
connection arm. While disconnecting the machine, do the opposite.
Connecting the pto shaft:
SERIES 4 P.T.O shaft which has Friction Limiter Clutch is used in Rotary Disc Mowers.
Before connecting the pto, clean the surfaces of spindle and lubricate them wtih grease.
Later shift the shaft on the pto spindle until the pin fits into safely. The shifting distance must
be at least 15 cm. Take pto shaft guard in a safety position by hanger. This safety position is
for the tractor and for the rotation of fixed parts.
P.T.O shaft can only be connected when the P.T.O connection and engine are switched off
and the ignition key is pulled down.
Connect the prescribed P.T.O. shaft and secure the P.T.O shaft connection by a chain
Make sure that the P.T.O shaft is in proper position on both ends. The adjustment of the
P.T.O shaft is necessary for different tractors. To find out the right length. Shorten both shafts
and proteciton tubes for exactly the same length.
To find the right length:
Connect the machine to the tractor.
Pull out the P.T.O shaft entirely and connect each separate half of the shaft to the tractor and
compare them wih each other.
If the covering of the P.T.O shaft and P.T.O shaft does not run into the block at horizontal
position. In case you need to shorten the P.T.O shaft.Shorten the shaft in exactly the same
length.