Farmi Forest CH180 AVANT, Руководство по эксплуатации и обслуживанию

Страница: 20 / 35

20
CH180 Avant
ASSEMBLING THE ATTACHMENT
Attaching the attachment to the loader is quick and easy, but it must be done carefully. The attachment is mounted
to the loader boom by using the quick attach plate on the loader boom and the counterpart on the attachment.
If the attachment is not locked to the loader, it may detach from the loader and cause a hazardous situation. The
loader must not be driven and the boom must never be lifted when the attachment has not been locked. To prevent
hazardous situations, always follow the coupling procedure shown below. Also remember the safety instructions
shown in this manual. The attachment is mounted to the loader as follows:
Crushing risk!
DANGER
1. Make sure that an unlocked attachment will not move or fall over
2. Do not stay in the area between the attachment and the loader
3. Mount the attachment only on level surface
4. Never move or lift an attachment that has not been locked.
AVANT QUICK COUPLING SYSTEM
STEP 1:
1. Lift the quick attach plate locking pins up and turn them backwards
into the slot so that they are locked in the upper position.
2. If your loader is equipped with a hydraulic attachment locking system,
see additional instructions about the use of the locking system from
the relevant manuals.
3. Ensure that the hydraulic hoses and the electric harness are not in the
way during installation.
STEP 2:
4. Turn the quick attach plate hydraulically to an obliquely forward
position.
5. Drive the loader onto the attachment. If your loader is equipped with
a telescopic boom, you can utilise this.
6. Align the upper pins of the loader’s quick coupling plate so that they
are under the corresponding brackets of the attachment.
STEP 3:
7. Lift the boom slightly – pull the boom control lever backward to raise
the attachment off the ground.
8. Turn the boom control lever left to turn the bottom section of the
quick attach plate onto the attachment.
9. Lock the locking pins manually or lock the hydraulic locking.
10.
Always check the locking of both locking pins.