MAINTENANCE, LUBRICATION AND
ADJUSTMENT INSTRUCTIONS
JL 601
B // En // 141001MRu
www.normet.fi
Normet Corporation
Ahmolantie 6
FIN --- 74510 PELTOSALMI
FINLAND
Tel. + 358 (0) 17 83 241
Fax. + 358 (0) 17 823 606
21
Page
12. TROUBLE SHOOTING
CONDITION
POSSIBLE CAUSE
REMEDY
Hard to pull the cable out
Drum brake is too tight
Loosen the drum brake. See
instructionsfrom item 10.3
”Adjusting the drum brake”.
Cable gets tangled on the
drum
Cable too loose on the drum.
The cable is pressed between
loose loops.
Loosen the pin and pull the
cable from the reel with the
help of a tractor. Reel the cable
tightly back in with the help of
the load
Cable develops kinks
Cable brake too loose
Tighten the drum brake.Tighten
cable on the drum by pulling
out the cable and by winching
with a heavy load.
Roller chain comes off
Roller chain too loose, some
part is broken or the aligning is
incorrect.
Check the aligment of the
chain. Check possible dam-
ages. Adjust the roller chain,
change if necessary. See chap-
ter 10.2 ”Adjusting the roller
chain”.
Rattling sound
Roller chain too tight, some
part is broken or the aligning is
incorrect.
Check the aligment of the
chain. Check possible dama-
ges. Adjust the roller chain,
change if necessary. See chap-
ter 10.2 ”Adjusting the roller
chain”.
Insufficient pull on the cable
Normal wear of the clutch. Mini-
mum thickness of the clutch
plates is 7mm
Oil or grease in the clutch
See chapter 10.1 ”Clutch
adjustment”.
Disassemble and clean the
parts
Front end of tractor comes off
ground when winching.
Tractor too light in front
Add front end weights
Tractor slides backwards when
winching
Parking brakes are not on.
Dozer blade does not anchor
the unit firmly to the ground.
Lock on the parking brakes
Lower the winch all way to the
ground.
