Farmi Forest Corporation CH180HF, Руководство по эксплуатации, техническому обслуживанию и запасным частям, Страница: 16 / 52

CH180HF
16
3-8 mm
OPERATION
Ensure that the feed funnel is empty. Turn on
the tractor hydraulics or connect an external
power source (OEM).
Before feeding the material, ensure that
nails, stones etc will not get into the chipper
amongst the material to be chipped.
If necessary, set the revolving speed of the
feeder reel to correspond to the revolving
speed of a grinding wheel. The speed is
suitable when the wood does not push against
the grinding wheel or the feeder reel spikes
do not slow down the feeding of wood. See
Setting the feeder speed.
Set the control handle in the FEED F position.
The feeder reel will begin to roll when the air
has left the hydraulic circuit.
Feed the wood into the feed chute. Let go of
the wood immediately after the feeder reel
begins to pull it.
INSTALLATION AND REMOVAL OF
THE FEEDING-ROLLER GUARDING
Remove the feeding-roller guarding (pg. 41, part
no. 33), when chipping twigs, willow trees or other
similar material, otherwise the twigs tend to roll
around the feeding-roller.
When chipping wood of diameters exceeding
70 mm, re-install the feeing-roller guarding to its
place.
Lift the roller arms as up as possible, for
example by feeding a tree butt-part into the
feeding machine of diameter 120 - 150 mm.
Remove the hydraulic hoses from the tractor.
Remove the external guarding from the feeing
machine.
Remove the cotter-pin and pull out the locking
bar.
Remove the feeding-roller guarding by open-
ing 3 pcs. of locking nuts.
Always put the removed parts (3 pcs. of
locking nuts M10, washer M16, locking bar
and cotter-pin) back onto the feeding-roller
guarding so that they will not disappear.
Install the external guarding back into place.
Connect the hydraulic hoses.
Remove the wooden butt-part from the feeding
machine.
The chipper is ready to be used.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Washer
0-4 pc
Feeding
roller
guarding
Feeding roller