Manual
TRIOLENT TX600-800PS
- 19 -
6.
MACHINE MAINTENANCE AND REPAIRS
Observe the safety instructions for treatment and maintenance.
If it is necessary to weld during the repair and have the machine connected to the tractor, it must have
disconnected supply cables from the alternator and the accumulator.
Check the tightening of all screw and other assembly connections at the machine before every use of the
machine, furthermore continuously as needed.
Continuously check the wear of the working bodies of the machine, possibly replace these worn working
bodies with new ones.
Adjustment, cleaning, and lubrication of the machine may only be performed with the machine at rest (i.e.
the machine is standing and not working).
When working on a lifted machine, use suitable support equipment supported at marked points or at points
suitable for that.
During adjustment, cleaning, maintenance, and repair of the machine, you must secure those parts of the
machine that could endanger the operator by falling or another movement.
For catching the machine during handling using lifting equipment, use only the places marked with self-
adhesive labels with the chain sign "
".
Upon a failure or damage of the machine, immediately turn off the tractor's engine and secure against
restarting, secure the machine against movement
only then you can remove the failure.
During repairs of the machine, use exclusively the genuine spare parts, suitable tools and protective
equipment.
Regularly check the prescribed pressure in the machine tyres and the condition of the tyres. Perform
possible repairs of the tyres in an expert workshop.
Keep the machine clean.
Do not clean hydraulic cylinders and bearings with a high-pressure cleaner or direct water stream. The
seals and bearings are not watertight at high pressure.
7.
MACHINE STORAGE
Long-term machine shutdown
:
Store the machine under a roof if possible.
Store the machine on a flat and solid surface with sufficient load capacity.
Clean the machine before storing and conserve so that it is not damaged in any way during storage. Pay special
attention to all marked lubrication points and properly lubricate them according to the lubrication plan.
Store the machine in the position with folded frames in the transport position. Store the machine on the axle and
the storage leg, secure the machine against spontaneous movement using scotches or another suitable tool.
When storing, lower the machine into the lower position using hydraulics.
The machine shall not be supported by chisels, otherwise there is a risk of their damage.
Secure the machine against access of unauthorised persons
.
8.
MACHINE LUBRICATION SCHEDULE
During machine maintenance and its lubrication, it is necessary to observe the safety regulations.
Table 4
–
Locations and Intervals of the Machine Lubrication
LUBRICATION POINT
INTERVAL
LUBRICANT
Tow bar joint
Fig4
- Daily, always before the work with the
machine.
- Always after the end of the season and
before storing the machine.
Plastic grease
Rubber-tyred rollers bearings
Fig.6
Disc bearings
Fig.5
- Always after the end of the season and
before storing the machine.
