Manual
TRIOLENT TX 300 N | TX 350 N
12
│
22
Bring the machine into the transport position.
The operator is obliged to pay increased attention during transport on roads, due to the transport
dimensions of the machine.
The operator must observe the valid regulations for transport on roads (laws, decrees) after connecting the
machine to the tractor, for reason of a change of the axle load. The driving properties of the set also
change depending on the terrain nature, adapt the manner of driving to these conditions.
The operator is obliged to present the machine certificate of roadworthiness as needed, according to the
valid regulations for road traffic (decree, law) (only in the Czech Republic)
–
It is valid only for
TRIOLENT TX300N.
The transportation width of the TRIOLENT TX350N machine is 3500mm, thus it is not possible to issue
a certificate of roadworthiness for it in the Czech Republic.
The operator is obliged to secure sufficient outlook during reversing from his position of the tractor
driver. In case of insufficient outlook, the operator is obliged to call a competent and informed person.
The operator must secure the arms of the rear TPS of the tractor in the transport position during road
transport, i.e. prevent unexpected arm drop using the hydraulic arm control lever. At the same time, the
arms of the rear TPS of the tractor must be secured against side swinging.
During machine transport on roads, the operator must observe the valid laws and decrees that deal with
this topic and which specify the relationships of the tractor axle load depending on transport speed.
5.
ADJUSTING THE WORKING DEPTH OF THE MACHINE
Execute the adjustment only when the machine is set on the shares or when it is recessed (see below).
1.
If the machine is equipped with a twin roller, first pull out the stopper securing the roller for
transport.
2.
Set the working depth by the upper stopper on the gate of the rear framework of the roller on the scale
from 1 to 16.
3.
Set the lengthwise level of the machine by the position of the bottom shoulders of the tractor and
adjusting the drawbar of the third point of the tractor, this will ensure even processing depth of the first
and second row of shares.
4.
Set the working depth of the rectifying discs by moving them in the holders and changing the position
of the stopper. Observe caution during the setting. Properly set discs will ensure perfect levelling and
covering by fine soil in the whole width of the swathe. When the disc depth is too low, there are lines
after the rear shares. When the discs are set too deep, there are tracks of heaped soil after the machine.
Check the proper setting of the discs during work
–
the setting may vary due to the soil conditions and
wear and tear of the discs.
You can use the auxiliary handle attached to the left side of the frame of the machinie for disc setting.
After putting the handle into the disc holder (Fig. 7), set the disc into the required position and secure
with a stopper.
There is a label for disc depth setting is located on the left side rectifying disc for better arrangement
(Fig.7). The values on the label are for orientation only and they do not have to correspond with the
values on the rear frame gate.
The working depth of the discs must never be identical with the working depth of the shares
–
“
X
”
.
5.
Recess the machine into the soil, leave it recessed and secure the machine by the bottom stopper on the
gate of the rear framework from undesirable falling of the rear frameworks with the roller on the main
machine framework when working on the plough turning end. Push the stopper into the closest hole
under the rear framework.
6.
The depth setting must be the same on the left and right side of the machine.
Содержание Triolent TX 300 N
Страница 22: ......
