8
│
25
Manual
KULTIS 6 | KULTIS 8
-
Only repair the machine when it is clean and the tank is empty and rinsed.
-
Any repair work performed in the tank of the machine may only be executed after the tank
has been thoroughly cleaned and provided that the operator wears a protective mask.
Another person outside the tank must supervise the work for safety reasons.
-
When replacing damaged parts, only use the spare parts supplied by the producer.
-
Regularly lubricate the entire machine according to the lubrication schedule.
-
When replacing pressure hoses, make sure that the new hose is of the same type and
same length.
-
Tighten the screw connections after the first few hours of operation.
-
Regularly check and tighten the screw connections. Pay extra attention to checking and
tightening the wheel nuts.
-
Tighten the wheel nuts after the first use of the machine.
-
Use appropriate support when the machine needs to be lifted for a repair.
-
The producer will supply a spare wheel at the user’s request.
-
The installation of tyres requires sufficient knowledge and prescribed installation tools.
Tyres may only be repaired by professional workers.
-
There is a risk of explosion when the air pressure in the tyres is high.
-
Regularly check the air pressure in the tyres.
-
Use appropriate tools and gloves when replacing working instruments with a blade.
-
Disconnect the cables from the accumulator prior to work with the electric equipment.
-
Prior to welding electric equipment, disconnect the cable from the alternator and the
accumulator. Attach the ground clamp near the welding area.
2.7.
Road Safety Requirements
-
Observe the relevant valid regulations when driving on roads.
-
When operated on roads, the machine must meet the provisions of Act No. 56/2001 Coll.
-
The highest speed limit for the set is 20 km.h
-1
-
Do not connect anything to the machine when transporting the set on roads.
-
It is not allowed to transport people on the machine.
-
The hydraulic control of the lower bars of the three-point hitch of the tractor must be
secured against accidental activation of the machine prior to the road transport.
