FARM-MAXX FTH Series, Руководство оператора

Страница: 21 / 39

FTH-Series Rotary Tillers
17
M =
S1 =
S2 =
Implement weight (kg)
Distance between rear axle and lower hitch points (cm)
Distance between lower hitch points and implement center of mass = 34 cm
5. OPERATING
Before operate the tiller, make sure you have read and understood the operating manuals of the
tiller, tractor and PTO shaft, and followed what is described in the section "Set Up".
DANGER
During operation, adjustment, maintenance, repairing or transportation of the machine, the operator
must always use appropriate Personal Protective Equipment (PPE).
Before starting work, ensure that all machine guards are in good conditions and fully functional.
During operation, the machine can throw material from the back: prevent people and animals to
approach the operational area.
5.1. START UP
Before the start up and before each use, perform the following pre-operation inspections and service
of the implement:
 check that the tiller has not damaged functional parts and has all mechanical parts in good
condition. Repair and / or replace the damaged parts;
 check that the tiller has no missing parts (pins, safety pins, plugs oil ...). Restore the missing
parts;
 check that all guards and safety devices have no damage and are properly positioned. Repair and
/ or replace the damaged shielding and restore them to the correct position;
 verify that the PTO driveshaft is properly installed (see section: Connection of the drive shaft);
 check that the driveshaft clutch is in good condition, and that its components are not subject to
"sticking" (see sections: Maintenance / Driveline);
 check the presence of lubricant in all greasing points of the tiller (driveshaft, supports...) (see
sections: Maintenance / Driveline and Maintenance / Support rotor);
 check for oil leaks from the gearbox or the transmission side cover. Identify the reason of loss,
then repair and / or replace the damaged components;
 check the correct oil level in the gearbox and in transmission side box (see section maintenance);
 check that blades are not excessively worn and the relating hardware is correctly tightened (see
section Maintenance);
 check that all the tiller hardware is properly tightened. Refer to the tightening table in the manual
for proper torque values;
 check that all safety decals are correctly positioned, in good condition and legible. Replace any
damaged decals;
 check that there is no constraints that may prevent the movement of equipment. Remove any
constraint.