FARM-MAXX FTH Series, Руководство оператора

Страница: 16 / 39

FTH-Series Rotary Tillers
12
4.1. LOWER HITCHES POSITIONING
The FTH-series tiller is designed to be mounted on tractors equipped with:
 3-point Hitch Category I (ISO 730 standard);
 3-point Hitch Category II (ISO 730 standard).
The position of the lower hitches must be adjusted accordingly.
If the tractor is equipped with a 3-point Hitch Category I (ISO 730 standard):
 verify that the lower clevises are equipped with I Category pins, so that the distance between
upper and the lower pins is 18'' (460 mm approx), as required from the standard (see figure). If
this not occurs, ask the Manufacturer or your Dealer a set of original I Category pins;
 verify that lower clevises on the square tube are at distance of 13 7/16'' from the center of tiller
PTO. The clevises shall be positioned symmetrically respect to tiller PTO, at distance of 26 7/8''
(683 mm) - see figure -:
If this not occurs, proceed as follows for each of the two clevises:
 loose the U-bolt clamping the clevis to the square tube;
 slide the clevis on the square tube, positioning it at distance of 13 7/16'' from the center of tiller
PTO. At the end of the operation the clevises shall be positioned symmetrically respect to tiller
PTO, at distance of 26 7/8'';
 re-tighten the U-bolt, referring to the tightening table of this manual.
If the tractor is equipped with a 3-point Hitch Category II (ISO 730 standard):
 verify that the lower clevises are equipped with II Category pins, so that the distance between
upper and the lower pins is 24'' (610 mm), as required from the standard (see figure). If this not
occurs, ask the Manufacturer or your Dealer a set of original II Category pins;
 verify that lower clevises on the square tube are at distance of 16 1/4'' from the center of tiller
PTO. The clevises shall be positioned symmetrically respect to tiller PTO, at distance of 32 1/2''
(825 mm) - see figure -: