FARGO electronics Color ID Card Printer II, Руководство по эксплуатации

Страница: 18 / 70

13
Cover
Release
Buttons
on/cancel
Card
Hopper
Door
clean/ribbon
on-line
Button
on/cancel
Button
laminator
LED
on-line
LED
D. Identifying
the Parts
1.
This illustration shows all of the control
buttons and the LED indicator lights found on the
front of the Color ID Card Printer. The
laminator
light indicates the current status of the printerÕs
built-in laminator. When the light is flashing, the
laminator is either heating up or cooling down.
When the light is solid, the laminator has reached
and is maintaining its target temperature.
The on/cancel button signifies that the printer
power is ON and also serves to cancel the current
print job and reset the printer for the next print job.
This button also ejects any cards left within the
printer after a print job is canceled.
The on-line button takes the printer on and off-
line. The printer must have the on-line light
illuminated in order to print. When flashing, the
on-line light also serves to indicate a print error
condition. Such conditions are discussed in
Section 10 of this manual.
The clean/ribbon light illuminates when your
ribbon supply is getting low. The light will
illuminate when approximately 10-20 prints are left
on the ribbon. The clean/ribbon light also serves as
a reminder that the printer should be cleaned
during every ribbon change (about every 250
prints) according to the steps in this manualÕs
Maintenance Section.