USE AND MAINTENANCE MANUAL - SECTION 4
ELEVAH 40 MOVE / 40 B AERIAL PLATFORM
– Rev. 12_2021
Page 4-21
The Supervisor Menu gives access to the following functions:
•
Changing Supervisor PIN;
•
Add / eliminate users;
•
Last User;
•
Maintenance cycle menu.
The User Menu gives access to the vehicle along with the option of carrying out the following
functions:
•
Changing user PIN;
•
Using the machine.
SUPERVISOR MENU
Access to the Supervisor Menu:
1. Press “00” to open the Supervisor Menu;
2. Enter the Supervisor’s code (4-8 digits);
3. Press “Power/Enter”
Ø
The high-pitched beep accompanied by green and red LEDs indicate that the Supervisor Menu
has been accessed correctly
NOTE:
Incorrect code entry is indicated by the red LED and a low-pitched acoustic sound.
NOTE 1:
The default Supervisor PIN is factory set at (00) 1234. It is advisable to change this code following
the instructions below in “Function 1”.
NOTE 2:
If the Supervisor PIN is lost or forgotten, the unit can be reset to the default PIN (00) 1234 by
simultaneously pressing 1, 3, 7 and 9 until the reset beep sounds, followed by the green and red LEDs flashing
4 times (after about 5 seconds). Press CE to confirm.
NOTE 3:
Key activation is always confirmed when any key
is pressed with a beep and the green LED flashing.
Once the Supervisor Menu is opened (as described above), the four permitted functions are now
available:
1. Changing the Supervisor PIN
2. Add / Eliminate users
3. Last User
4. Maintenance menu
Function 1 - Changing Supervisor PIN:
1. From the Supervisor Menu, press “1” and then press the “Power/Enter” key to access the
changing Supervisor PIN function;
Ø
The high-pitched beep and single flashing of the red LED indicate that function 1 has been
accessed correctly.
2. Enter a 4 - 8 digit PIN and then press the “Power/Enter” key;
Ø
The green LED will flash as many times as the number of digits entered (4-digit PIN = 4 flashes).
3. To confirm, enter the 4 - 8 digit PIN entered before and then press the “Power/Enter” key;
Ø
The high-pitched beep accompanied by the green and red LEDs lighting up indicate that the new
PIN has been accepted.
