28
english
7. MOUNTING
You can either use screws or adhesive strips to mount the weekly
thermostat to a wall in the frame supplied or integrate it into an
existing switch.
ADHESIVE STRIP MOUNTING:
Choose a site for installation. The surface on which you are mounting
the weekly thermostat must be clean, dry and greaseless. For mounting
of the assembled weekly thermostat attach the adhesive strips to the
back side of the mounting plate. You should be able to read the letters
on the back side (according to
fi
gure).
Remove the protective
fi
lm from the
adhesive strip. Press the assembled
weekly thermostat with the back side
to the wall in the position where it
should subsequently be attached.
SCREW MOUNTING:
Choose a site for installation. Make
sure that electrical lines in the wall
will not be damaged. Position the
mounting plate on the desired site
on the wall. Make sure that the arrow
on the mounting plate is pointing
upwards. Use a pen to mark the
positions of 2 bore holes A (diagonally
opposite) in the mounting plate on the
wall. The bore holes B can be used for
installation with a
fl
ush-mounting box.
Use the screws and plugs supplied to
fasten the mounting plate to the wall.
Attach the weekly thermostat with the
frame on the mounting plate. Make
sure that the arrows on the back
side of the weekly thermostat point
upwards and that the clips on the
mounting plate latch into the openings
on the weekly thermostat.
Figura 1
Figura 2
