Stirring Fluid Loss Manual
100031980
Revision F
21
Figure 5-1 Flexible Drive Shaft
14.
Turn the instrument on by moving the
Master s
witch (front panel) to the
On
position.
15.
Start stirring motor by moving the
Motor
switch (front panel) to the
On
position. Note that the paddle and shaft are turning properly. If necessary,
review Section 7 for troubleshooting and maintenance instructions. Turn off the
stirring motor. Next, proceed with pressure test.
16.
Place brass spacer ring into open end of sample chamber.
17.
Install O-ring on top of brass spacer ring (no grease applied). Make sure O-ring
is well seated against spacer ring.
18.
Insert the filter screen with fine mesh side facing down.
19.
Insert a second O-ring (slightly greased) on top of the screen.
20.
Screw cell cap onto the reservoir end. It should be as nearly flush as possible
with reservoir end. Use special wrench to tighten the cap.
21.
Close the supply pressure valve on the cap.
22.
Close the nitrogen vent,
N
2
Vent
.
23.
Slowly open nitrogen supply,
N
2
Supply
and listen for leaks.
24.
Open supply pressure valve on the paddle cap assembly.
25.
Rotate nitrogen pressure regulator to 1000 psi (7000 kPa). API RP10B-2
recommends 1000 ± 50 psi (7000 ± 300 kPa) be maintained during the test.
Do not exceed 1500 psi. Chamber pressure should allow for 100
psi differential between chamber pressure and backpressure
system (not to exceed 500 psi).
Содержание 210194
