6
How to Assemble Your Ceiling Fan (cont’d)
6.
Loosen the two setscrews in the Downrod Support. Align
the Clevis Pin holes in the Downrod with the holes in the
Downrod Support. Install the Clevis Pin and secure with the
Hairpin Clip. (Figure 5) Be sure to push the straight leg of the
hairpin clip through the hole near the end of the clevis pin until
the curved portion of the hairpin clip snaps around the clevis
pin. The hairpin clip must be properly installed to prevent the
clevis pin from working loose. Pull on the Downrod to make
sure the clevis pin is properly installed.
7.
Route wires and support cable through Motor Coupling
Cover and through opening in Canopy. Position Canopy
Screw Cover and Canopy on fan shown with open side facing
up. (Figure 7)
8.
Reinstall the Hanger Ball (Figure 4) on the Downrod as
follows. Route the three 80˝ wires and support cable through
the Hanger Ball. Position the Pin through the two holes in
the Downrod and align the Hanger Ball so the Pin is captured
in the groove in the top of the Hanger Ball. Pull the Hanger
Ball up tight against the pin.
Securely tighten the setscrew
in the Hanger Ball. A loose setscrew could create fan
wobble.
9.
While pulling up on the hanger ball, securely tighten the
two setscrews with nuts in the downrod support.
(Figure 5)
NOTE: The setscrews must be properly installed as described
above, or fan-wobble could result.
10.
Slide the Motor Coupling Cover down until it touches the
top of the Housing. (Figure 6)
9.
Before installing fan, measure up approximately 6-9 inches
above top of Downrod/Hanger Ball Assembly. Cut off excess
wire and strip back insulation ½˝ from end of wire.
10.
You have now completed the upper assembly of your
ceiling fan. You can now proceed with the hanging and the
electrical wiring of your fan.
Clevis Pin
Canopy
Canopy
Screw
Cover
Motor
Coupling
Cover
Figure 5
Figure 7
Figure 6
Hairpin Clip
Screw (2)
▲
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
NOTE:
All set screws must be checked and re-tightened
where necessary before installation. (See Maintenance,
page 12)
