Fanimation The Caruso FP7000 Series, Руководство пользователя, Страница: 4 / 18

4
Electrical and Structural Requirements
Your new ceiling fan will require a grounded electrical supply
line of 120VAC, 60 Hz, 15 amp circuit. The outlet box must
be securely anchored and capable of withstanding a load
of at least 100 lbs. Figure 1 depicts different structural
con
fi gurations that may be used for mounting the outlet
box.
If your fan is to replace an existing light
fi xture, turn
electricity off at the main fuse box at this time and remove
the existing light
fi xture.
2 ˝ x 4 ˝
Ceiling
Joists
Ceiling
Outlet
Box
Figure 1
▲ WARNING
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
▲ WARNING
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and the
ceiling fan must be properly grounded as a precaution
against possible electrical shock.
This Lag Bolt is
fastened securely
Hanger
Bracket is
loose and
free to rotate
This Lag Bolt is NOT
fully fastened
Figure 1
Fan Alignment And Hanger Bracket Installation
1. Attaching Ceiling Support Cable (Figure 1): Drill ¼ ˝
pilot hole through one of the four corners of the junction
box, into the ceiling joist or structural member. Securely
attach the ceiling support cable with
3
⁄
8
˝ x 2 ˝ lag bolt and
fl at washer.
NOTE: Ceiling support cable must be fastened between
fl at washer and junction box with 2 ˝ lag bolt (Figure 1).
2. Preliminary Hanger Bracket Attachment (Figure 1): Drill
¼ ˝ pilot hole through the center of the junction box, into
the ceiling joist or structural member. LOOSELY attach
hanger bracket to the ceiling structure using
3
⁄
8
˝ x 5 ˝ lag
bolt and fl at washer. DO NOT FULLY TIGHTEN THE LAG
BOLT YET! Hanger Bracket should be free to rotate.
3. Separate and untwist the three motor leads and safety
cable. Remove hanger ball & pin prior to routing wires.
Route the motor leads and safety cable through the bottom
end of the downrod as shown (Figure 2).
▲ WARNING
Failure to follow these Hanger Bracket installation
procedures may result in damage to Hanger
Bracket.
Downrod
Support Bar
Figure 2