Tighten Nut
After Setting
Angle
Figure 2
12
Adjusting and Setting the Motor Head Angles
NOTE:
This step is applicable after the necessary fan
assembling, hanging and wiring is completed.
1.
Remove knee caps from both side of each knee joints by
twisting counter-clockwise. Figure 1 shows the angle tick
mark details on both sides of “knee-joint” on the motor.
NOTE:
The single screw (per each motor) serves as the
index stop for each angle setting.
See chart below.
2.
Be sure to secure the screw
as shown per each motor in the
corresponding chart below:
3.
After setting corresponding motor
head angles, be sure to securely
tighten the nut on the knee bolt.
(Figure 1)
4.
Secure the knee covers on the
knee bolts on both side of each knee
joint. (Figure 2)
CAUTION
To reduce the risk of personal injury or damage to fan
assembly, be sure to support the motor heads when
adjusting or changing angles on the “knee-joint”.
INSTALLATION NOTE
BOTH MOTOR HEADS
MUST
BE SET AT THE SAME
ANGLE!
CAUTION
Do NOT Fully Remove The Center
Knee Bolt, Only Loosen.
Figure 1
Angle
Setting
Illustration
Side A
of Joint
Side B
of Joint
0°
Vertical
15°
30°
45°
60°
Tick Mark on 0°
Screw
Screw
Screw
Screw
Screw
Tick Mark on 30°
Tick Mark on 60°
Tick Mark on 15°
Tick Mark on 45°
NOTE:
22
˝
Natural Palm Blades Are
NOT
To Be Used At The 60° Setting.