8
Figure 1
How to Assemble Your Ceiling Fan
Downrod
Set Screw
Pin
Hanger Ball
1
.
Remove the hanger ball
portion
from the downrod/
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for reinstal-
lation in Step 6. (Figure 1)
2.
Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
Figure 2
Hairpin Clip
Clevis Pin
Figure 5
4.
Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Install and tighten the
two set screws with nuts in the downrod support.
(Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
5.
Route wires through motor coupling cover, canopy
screw cover and ceiling canopy. (Figure 5)
Figure 4
Downrod
Set Screws and
Locking Nuts (2)
Hairpin Clip
Clevis Pin
Figure 3
Black/White, Blue, Red,
Gray and Yellow wires
Motor Coupling
Cover
Ceiling Canopy
Canopy Screw
Cover
3.
Route the black/white, blue, red, gray and yellow
wires through the downrod. (Figure 3)
