14
How to Operate Your Ceiling Fan
MAIN FUSE BOX
Figure 2
Figure 1
For illustrative purposes only
-not
intended to cover all types of controls
1.
IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
2.
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
NOTE:
The fan's receiver features an automatic learning
function. There are no frequency switches on the receiver
unit. The receiver will automatically scan the frequency
from the hand held control if any changes are made.
The frequency settings should only be changed in the
case of interference or if multiple ceiling fans with the
same type of control system are installed in the same
structure.
3.
To make fan operational, install two 3V batteries
(included) in hand-held remote transmitter, with fan
power off. Then, follow the remote code setting process.
If not used for long periods of time, remove battery to
prevent damage to transmitter. Store the remote away
from excessive heat or humidly. (Figure 3)
3V, CR2032
BATTERY
3V, CR2032
BATTERY
Figure 3
3V CR2032
Battery (2 pcs)
Figure 4
SET
Dip Switch
4. Remote Control Setting and Speed (RPM)
Setting Process : (Figure 4)
1) When powering on your fan, do not press any
button(s) before pressing the “SET” button, otherwise
the learn procedure will fail. If you press a button before
the “Set” button, please turn the power off, then on
again, and start the process over.
2) After installing the unit and restoring power to your fan,
press and hold the “SET” button 1-5 seconds. You must
press the “SET” button within 30 seconds of restoring
power to the fan.
3) The fan will make two musical sounds and light will
blink twice, which signals your remote and fan have
synchronized. The fan is now ready for normal use.
Do not operate this fan with a variable (Rheostat)
wall controller or dimmer switch. Doing so could
result in damage to the ceiling fan's remote control
unit.
WARNING
