17
1.
Check main and branch circuit fuses or circuit breakers.
2.
Check line wire connections to fan and switch wire
connections in the switch housings.
CAUTION: Make sure main power is turned off !
CAUTION: Make sure main power is turned off !
3.
Replace with fresh battery.
1.
Attach blades to fan before operating.
2.
Check to make sure all screws in motor housing are snug
(not over-tight).
3.
Check to make sure wire connectors in switch housing are
not rattling against each other or against the interior wall of
the switch housing.
4.
Some fan motors are sensitive to signals from solid-state
variable speed controls. Solid-state controls are not
recommended, choose an alternative control method.
1.
Tighten both setscrews securely in downrod support.
2.
Tighten the setscrew in the downrod/hanger ball assembly.
3.
Check to be sure screws which attach the fan blade to the
motor assembly are tight.
4.
Tighten the hanger bracket screws to the outlet box, and
secure outlet box.
1.
If possible, consider using a longer downrod (not included,
you can buy the longer downrod from fanimation.com).
1. FAN WILL NOT START.
2. FAN SOUNDS NOISY.
3. FAN WOBBLES
EXCESSIVELY.
5. NOT ENOUGH AIR
MOVEMENT.
4. REMOTE CONTROL
DOES NOT WORK. THE
CONTROL INDICATOR
LED IS CONSTANTLY
FLASHING.
1.
Fuse or circuit breaker blown.
2.
Loose power line connections to the fan, or loose
switch wire connections in the switch housing.
3.
Dead battery in remote control.
4.
Make sure reverse switch position is all the way to one side.
4.
Reverse switch in neutral position.
1.
Blades not attached to fan.
2.
Loose screws in motor housing.
3.
Wire connectors inside housing rattling.
4.
Motor noise caused by solid state variable speed
control.
1.
Setscrew in downrod support is loose.
1.
Please replace the battery/batteries.
1.
The battery/batteries are going to run out.
2.
Setscrew in downrod/hanger ball assembly is loose.
3.
Screws securing fan blade to motor assembly are
loose.
4.
Hanger bracket and/or ceiling outlet box is not
securely fastened.
Troubleshooting
Periodic cleaning of your new ceiling fan is the only
maintenance necessary.
When cleaning, use only a soft brush or lint free cloth to
avoid scratching the finish.
Abrasive cleaning agents are not required and should be
avoided to prevent damage to finish.
Periodic light dusting of the blades is recommended.
A feather duster will work best.
Avoid using water, cleansers, or harsh rags, which
can warp and ruin the blades.
How to Clean Your Ceiling Fan Blades
Maintenance
CAUTION
Do not use solvents when cleaning your ceiling fan.
It could damage the motor or the blades and create
the possibility of electrical shock.
For your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan.
WARNING
Trouble
Probable Cause
Suggested Remedy